期刊信息
  • 主管单位:
  • 上海市科学技术协会
  • 主办单位:
  • 上海有色金属学会
    上海理工大学
  • 名誉主编:
  • 陈兴章
  • 主    编:
  • 刘 平
  • 地    址:
  • 上海市军工路516号
  • 邮政编码:
  • 200093
  • 联系电话:
  • (86)021-55781550
  • 电子邮件:
  • nmme@usst.edu.cn
  • 国际标准刊号:
  • 2096-2983
  • 国内统一刊号:
  • 31-2125/TF
  • 单    价:
  • 8.00
  • 定    价:
  • 60.00
金鑫焱,林传华,任玉苓,王凯,吴广新.Al-Cr中间合金在熔融Al-Zn-Mg-Si-Fe镀液中的扩散反应研究[J].有色金属材料与工程,2023,44(2):45-51.
Al-Cr中间合金在熔融Al-Zn-Mg-Si-Fe镀液中的扩散反应研究
Study on the diffusion reaction of Al-Cr master alloy in molten Al-Zn-Mg-Si-Fe bath
  
DOI:10.13258/j.cnki.nmme.2023.02.006
中文关键词:  Al-Cr中间合金  扩散  Al-Zn-Mg-Si-Fe  热浸镀
英文关键词:Al-Cr master alloy  diffusion  Al-Zn-Mg-Si-Fe  hot-dip galvanizing
基金项目:上海市自然基金资助项目(21ZR1423600);中央引导地方项目(216Z1004G)
作者单位
金鑫焱 宝钢研究院, 上海 201999
汽车用钢开发与应用技术国家重点实验室(宝钢), 上海 201999 
林传华 宝钢冷轧厂, 上海 200941 
任玉苓 宝钢冷轧厂, 上海 200941 
王凯 宝钢研究院, 上海 201999
汽车用钢开发与应用技术国家重点实验室(宝钢), 上海 201999 
吴广新 上海大学材料科学与工程学院&先进特殊钢国家重点实验室&先进铁冶金上海市重点实验室, 上海 200444 
摘要点击次数: 0
全文下载次数: 0
中文摘要:
      以Al-Cr中间合金锭和熔融Al-Zn-Mg-Si-Fe镀液为研究对象,研究了Al-Cr中间合金锭浸入含不同质量分数Fe的630 ℃熔融镀液15 h的扩散反应。使用扫描电子显微镜、能谱仪分析了扩散前后Al-Cr中间合金锭组织和成分的变化,同时研究了镀液中Fe质量分数对Cr溶解度的影响。研究发现,随着镀液中的Zn、Mg、Si、Fe长时间向Al-Cr锭内部扩散,Al-Cr锭中原有的Al基体的组织转变成了与镀液成分相近的组织,原有的富Cr第二相转变成了Al-Cr-Zn-Si相和Al-(Fe, Cr)-Si相。随着Al-Cr锭中的Cr向镀液扩散,镀液中Cr质量分数升高,并在5 h后达到饱和。由于Cr和Al、Fe、Si优先形成了Al-(Fe, Cr)-Si金属间化合物,因此镀液中的Fe显著降低了Cr元素的饱和溶解度,当镀液Fe质量分数由0.10%增加至0.42%时,镀液中Cr质量分数由0.047%~0.059%减少至0.012%~0.016%。
英文摘要:
      The diffusion reaction of Al-Cr master alloy ingot in molten Al-Zn-Mg-Si-Fe bath was studied when Al-Cr ingot was immersed in the molten bath with different Fe mass fraction at 630 °C for 15 h. The microstructures and compostions of the as received and diffused Al-Cr master alloy ingots were analyzed by scanning electron microscope and energy dispersive spectrometer, and the effect of Fe mass fraction in the bath on the solubility of Cr was also studied. The results show that with sufficient diffusion between the solid ingot and the molten alloy bath, the composition and microstructure of the matrix of the as received Al-Cr ingot were turned to a composition and microstructure close to the bath due to the diffusion of Zn, Mg, Si and Fe in the alloy bath to the Al-Cr ingot. The Cr-rich secondary phases in the as received Al-Cr ingot were transformed into Al-Cr-Zn-Si phase and Al-(Fe, Cr)-Si phase. As Cr diffused into the alloy bath, the Cr mass fraction of the bath increased and reached saturation after 5 h. Since Cr and Al, Fe, Si elements preferentially formed Al-(Fe, Cr)-Si intermetallic compounds, the existence of Fe in the molten bath significantly reduced the saturated solubility of Cr. When the Fe mass fraction in the bath increased from 0.10% to 0.42%, the Cr mass fraction of the bath decreased from 0.047%-0.059% to 0.012%-0.016%.
HTML   查看全文  查看/发表评论  下载PDF阅读器